OBD GW X200

Wiring, batteries, console and Great Wall compatible electronic gadgets discussion.

OBD GW X200

Postby flyfisher63 » Wed Aug 09, 2017 7:15 pm

Hi can anyone tell me what series the OBD plug is in the GW X200 is it OBD or OBD II (including the CAN, VPW, PWM, ISOand KWP 2000 protocols)?
flyfisher63
Great Wall Fan
Great Wall Fan
 
Posts: 33
Joined: Fri Jun 29, 2012 7:46 pm
Location: Berowra Heights NSW

Re: OBD GW X200

Postby pal » Thu Aug 10, 2017 6:15 am

It is OBD!!
This is the pin configuration for the OBD on the X200


All documentation on the Great Wall Hover 
Diagnostic connector OBD II, fault codes



Key contacts 

1 - OEM 
2 - J1850 Bus + (Bus + Line, SAE) 
3 - OEM 
4 - Body Ground 
5 - Signal ground 
6 - Upper contact CAN (J-2284) 
7 - K Line ISO 9141-2 
8 - OEM 
9 - OEM 
10 - Bus - Line, Sae J1850 bus 
11 - OEM 
12 - OEM 
13 - OEM 
14 - CAN bottom contact (J-2284) 
15 - L Line ISO 9141-2 
16 - Battery voltage 
Harold

Image
pal
Great Wall Wizard
Great Wall Wizard
 
Posts: 88
Joined: Sun May 12, 2013 7:23 am
Location: Bundaberg

Re: OBD GW X200

Postby Escapable » Thu Aug 10, 2017 9:08 pm

I guess all forgot to mention:

It is OBD2 .. OBD1 was an earlier implementation and was limited by sensors, etc.. The GW's are quite advanced electronically. Most decent Scantools and adapters do both 1&2.

As for the connections, these do not all appear on all plugs, as they allow for different systems to be connected.
If you plug a recently produced OBD monitor or Scantool in there, it will auto select the adapted protocol.
Look at the connector as the interface connector on your internet modem thingy.
Blue X200 Auto 2013 (Pro Racing OBD Chipped)
Most cars are assembled from Chinese parts: Why not bring in the whole car?
Escapable
Great Wall Legend
Great Wall Legend
 
Posts: 182
Joined: Fri Jan 24, 2014 9:30 pm


Return to Electrical and Electronic Systems

Who is online

Users browsing this forum: No registered users and 2 guests